Konica Minolta Magicolor 2430 DL User Manual page 108

Symptom
Printing
takes too
much time.
Blank pages
are printed.
Printer
returned to
READY
before the
configura-
tion menu
was
changed.
100
Cause
The printer is set to a
slow printing mode
(for example, thick
stock or transpar-
ency).
The printer is set to
power saving mode.
The job is very com-
plex.
The printer memory is
insufficient.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed
(
INCORRECT
is dis-
CART. X
played in the mes-
sage window).
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The printer was in the
configuration menu
structure without a
selection being made
within two minutes.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it. (
/
SERVICE ENERGY SAVER
Wait. No action needed.
Add more memory.
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific printer.
Check the toner cartridges. The image
will not print correctly or not at all, if the
cartridges are empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
When in the configuration menu struc-
ture, select your choice within 2 min-
utes.
Solving Other Problems
/
ENGINE
menu)