Table of Contents
Advertisement
Symptom
You are
experienc-
ing prob-
lems
duplexing.
Transfer
belt can-
not be
removed.
The
printer
pauses.
Solving Other Problems
Cause
Media or settings
are not correct.
The OPC drum unit
is installed.
The transfer belt
left release lever is
not set in the trans-
fer belt removal
position.
The printer pauses
for the Auto-Image
Density Control
(AIDC) cycle.
Solution
Make sure that you are using only plain
paper. Do not duplex envelopes, glossy
stock, labels, postcards, transfer media,
or transparencies. Make sure that you
have not mixed media types in your
multipurpose tray.
Make sure that your document has
more than one page.
Go into the printer's control panel and
make sure that duplex is an available
option.
In the printer driver, choose Short Edge
(flipped as on a clipboard) or Long Edge
(flipped as in a loose-leaf notebook).
Make sure that you are using correct
media.
Make sure that all of the covers are
closed. Open and then close the covers
to confirm that they are securely closed.
If you turned the printer off, make sure
that you have turned the printer on
again and waited for it to warm up
Remove the OPC drum unit first, then
remove the transfer belt.
Turn the transfer belt left release lever
clockwise to the 4 o'clock position, then
remove the transfer belt.
After 100 1-sided pages of a continuous
print run, the magicolor 2210 automati-
cally pauses to do an AIDC cycle. This
process is provided to make sure
reliable printer operation with optimum
output quality.
73
Advertisement
Table of Contents
