QMS Crownnet Setup Manual page 45

choose the Refresh command to display a message such as OK,
Busy, Offline, Occupied, or Out of Paper. If the No
Response message persists, or if an Internal Error
message displays, either refer to the CrownNet Print Utility on-line
help for advice on further action or close the utility and restart it.
7 In the Port menu, choose Connect to bring up Print Manager.
8 In the Printer menu, choose Create Printer.
9 Type a name in the Printer Name field, select a suitable
printer driver from the Driver list, then select the Windows
port name you installed in steps 2-4, and choose OK.
The Windows port name will be near the bottom of the Ports list
and will be in this format: drive :\ directory \ port , where drive is the
spooling drive, directory is the spooling directory, and port is the
CrownNet Windows port name.
10 If you installed more than one Windows port, repeat steps 6-
10 for each Windows port you installed.
11 Close the Print Manager.
The setup is now complete, and you can immediately print through
your CrownNet port. Refer to the QMS CrownNet System Administra-
tor's Guide for additional information on setting up serverless and cli-
ent-server (server-based) printing.
» Note: The QMS CrownNet Print Utility for Windows must be running
when you print to your CrownNet port. We strongly recommend that,
if you haven't already, you place the CrownNet Print Utility for
Windows (CROWNPUW.EXE) into your Startup folder.
» Note: Windows 95 requires preinstallation of the Microsoft Windows
Network running the NetBEUI Protocol, NetBIOS Interface, and
Workstation and/or Server network software. Refer to your Windows
documentation for installation instructions.
1 Open the CrownNet Print Utility.
2 In the Port menu, choose Add.