QMS Crownnet Setup Manual page 14

The method you use to connect your printer to the network depends
on whether you're connecting to an Ethernet network (described
below) or a Token-Ring network (described on page 15).
n
For thin-wire Ethernet (10Base2, BNC connector) see the next
section.
n
For thick-wire Ethernet (10Base5, AUI connector)—not available
for some printers—see page 13.
n
For twisted-pair Ethernet (10BaseT/100BaseTX, RJ45 connec-
tor) see page 14.
Thin-wire Ethernet connections use BNC connectors.
BNC 50 Ohm
Terminator
Caution: Unless the BNC "T" connector is already installed on the
thin-wire Ethernet cable, your network's operation is disrupted during
the connection process.
1 Turn off the printer, and unplug the power cord.
2 If the BNC "T" connector is already installed, go to step 3.
Otherwise, attach one section of thin-wire Ethernet cable to
one end of the BNC "T" connector.
BNC "T"
Connector