QMS Crownnet Setup Manual page 39

Unless you want to use the default settings, use the following proce-
dure to name the file and print servers. These names must be unique.
» Note: In CrownAdmin 3, the printer shows up as QMS-xxxx-Print-
System-hardwareaddress, where xxxx is the printer model
number and hardwareaddress is the printer's hardware address as
found on the printer start-up page.
1 In the Administration/Communications/ xxxxxxxx NIC/Crown-
Net/NetWare/Config PServer/PServer Context[1], PServer
Context[2], and PServer Context[3] menus (where xxxxxxxx
is either Resident or Optional), enter the name of the config-
uration file server and print server context.
» Note: The three PServer Context[x] menus allow you to identify
the name of the NDS configuration file server and the print server
context.
The format for the option is
n
File server name
n
Space
n
Print server context
For example, if the configuration file server name is QMS-4 and
the print server context is PRINTSERV2.SALES.QMS, you would
enter:
QMS-4 PRINTSERV2.SALES.QMS
» Note: Make sure to put a space between the file server name
(QMS-4) and the print server context
( PRINTSERV2.SALES.QMS).
Up to 16 characters can be entered in the Pserver Context[1]
field, and additional 16 characters in Pserver Context[2] field, and
15 characters in the Pserver Context[3] field.
Note: If you need to assign more than 14 characters to the file
»
server name you must use CrownAdmin 3 to enter the name.