QMS 2060 User Manual page 145

3 Remove the controller board.
Using both hands, grab the two screws (on the metal mounting
bracket cover), slide the controller board out of the printer, and
set-it aside on a flat surface.
4 Position the controller board on a flat surface, so the control-
ler board lies flat and the bracket is facing you.
5 If necessary, remove an existing SIMM.
a Release the SIMM.
Pull the latches on each side of the SIMM connector outward
using both thumbs.
b Remove the SIMM.
Tilt the SIMM backwards to a 45° angle away from the SIMM
connector, and then lift it out.
6 Remove the new SIMM from the anti-static bag.