Table of Contents
Advertisement
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
ASSEMBLING THE STAND
Tools Needed (Not Included):
• 10mm Socket or Combination Wrench (2)
• 13mm Socket or Combination Wrench (2)
• 9/16 or 14mm Combination Wrench (1)
• Bubble Level (1)
1. Lay one stand leg (Fig. 1 - 1) flat on a level surface. Attach the two
stand braces (Fig. 1 - 2) to the stand leg using four M6x16 hex bolts
(Fig. 1 - 3), four 6mm flat washers (Fig. 1 - 4), and four M6 flange
nuts (Fig. 1- 5).
NOTE: Hand tighten the stand fasteners only. Once the stand is com-
pletely assembled, you can then fully tighten the stand fasteners.
2. Repeat step 1 to attach the remaining stand leg to the other sides
of the two stand braces.
3. Flip the stand over so that the four feet brackets (Fig. 2 - 1) are fac-
ing up. Place a hex nut (Fig. 2 - 2) and a flat washer (Fig. 2 - 3) onto
the threaded end of a stand foot (Fig. 2 - 4) before placing the foot
through the foot bracket. Secure the foot to the foot bracket using a
flat washer and a hex nut as shown in Fig. 2.
4. Repeat step 3 for the remaining three feet.
5. Flip the stand to the upright position so that the feet are on the floor.
Attach the stand top (Fig. 3 - 1) to the stand legs using eight M8x16
Carriage Bolts (Fig. 3 - 2) and eight M8 hex nuts (Fig. 3 - 3).
6. Place a level (not included) on the stand top and adjust the stand
feet as necessary. Make sure that both hex nuts on the feet are tight
against the stand. Make sure to level the stand from both front to back
and side to side.
12
ASSEMBLY & ADJUSTMENTS
2
3
1
2
3
Fig. 1
5
4
1
Fig. 2
4
2
3
1
Fig. 3
Advertisement
Table of Contents
