Electrical Information - Wen BA1411 Instruction Manual

14-inch two-speed band saw

Hide thumbs

Table Of Contents

Table of Contents

GROUNDING INSTRUCTIONS

In the event of a malfunction or breakdown, grounding provides the path of least resistance for an electric current

and reduces the risk of electric shock. This tool is equipped with an electric cord that has an equipment grounding

conductor and a grounding plug. The plug MUST be plugged into a matching outlet that is properly installed and

grounded in accordance with ALL local codes and ordinances.

1. Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a licensed electri-

cian.

2. Improper connection of the equipment grounding conductor can result in electric shock. The conductor with the

green insulation (with or without yellow stripes) is the equipment grounding conductor. If repair or replacement

of the electric cord or plug is necessary, DO NOT connect the equipment grounding conductor to a live terminal.

3. Check with a licensed electrician or service personnel if you do not completely under-

stand the grounding instructions or whether the tool is properly grounded.

4. Use only three-wire extension cords that have three-pronged plugs and outlets that

accept the tool's plug. Repair or replace a damaged or worn cord immediately.

CAUTION! In all cases, make certain the outlet in question is properly grounded. If you

are not sure, have a licensed electrician check the outlet.

GUIDELINES AND RECOMMENDATIONS FOR EXTENSION CORDS

When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An

undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table below shows

the correct size to be used according to cord length and ampere rating. When in doubt, use a heavier cord. The

smaller the gauge number, the heavier the cord.

AMPERAGE

11A (110V - 120V Operation)

AMPERAGE

5.5A (220V - 2240V Operation)

1. Examine extension cord before use. Make sure your extension cord is properly wired and in good condition.

Always replace a damaged extension cord or have it repaired by a qualified person before using it.

2. Do not abuse extension cord. Do not pull on cord to disconnect from receptacle; always disconnect by pulling

on plug. Disconnect the extension cord from the receptacle before disconnecting the product from the extension

cord. Protect your extension cords from sharp objects, excessive heat and damp/wet areas.

3. Use a separate electrical circuit for your tool. This circuit must not be less than a 12-gauge wire and should

be protected with a 15A time-delayed fuse. Before connecting the motor to the power line, make sure the switch

is in the OFF position and the electric current is rated the same as the current stamped on the motor nameplate.

Running at a lower voltage will damage the motor.