Cutting Around Drawings - Brother SDX325 Operation Manual

c
Raise the scanner lever (on the left side of the
machine) to "2".
d
Load the mat with the material for drawing
(cutting) attached.
• Lightly insert the mat into the feed slot, and press
in the operation panel.
• For details on inserting the mat, see "Loading the
Mat" on page 28.
e
Select "Draw" in the preview screen.

The drawing line (blue) appears.
f
Adjust the drawing speed and pressure.
Before drawing the pattern, adjust the drawing speed
and pressure. These adjustments can be made from the
settings screen. Touch

Touch or
58
.
to change the settings.
Note
• If the drawing pressure is too high, the pen tip
may be damaged. Adjust it to an appropriate
setting.
Memo
• Adjustments to the drawing pressure will affect
the finished product. Use the same material
that the pattern will be drawn on to make the
adjustments.
g
Touch the "Start" key to start drawing.
Note
• After use, remove the pen from the pen holder,
and then attach the cap to the pen before
storing it.

Cutting Around Drawings

In this example, we will specify a seam allowance
for a built-in pattern and draw the pattern, then cut
an outline around it.
■ Specifying the Seam Allowance
a
Select the pattern to be drawn, and then touch
the "Set" key.

The mat layout screen appears.
b
Touch the "Edit" key.