Table of Contents
Advertisement
2.8
Audio Settings Page
The Audio Settings page allows the administrator to adjust specific device properties not covered
in other configuration pages such as master volume settings, LCD contrast and other feature
settings. See Figure 8.
Figure 8
•
LCD Settings – Allows the administrator to adjust brightness & contrast of device display. Slide
right to increase, left to decrease.
•
Audio Settings – Allows the administrator to adjust master speaker volume & microphone gain
of device. Speaker & microphone level meters are provided as simple diagnostic tools to
confirm if device is working properly. Master volume level suggested is 0 to10 and Mic Volume
level suggested is 0 to10.
•
Test Speaker – Pressing this button plays a test message on the device.
•
Packet Size – From the drop down either 10ms or 20ms packet size can be selected depending
on use case. It is highly recommended to leave the setting at 10ms when used with adjacent
CS-64's. The 20ms setting is used in special situations for interfacing with 3
which does not support 10ms packet size.
•
Start Announcement – If this box is checked the device will play a message indicating it is
being restarted any time the device experiences a reload or reboot.
•
Handsfree Allowed – Check to enable hands free functionality. A user may simply press and
quickly release the desired channel PTT button to engage hands free operation. Device
display will indicate "HF" on the selected channel.
•
Handsfree Timeout – This setting allows an administrator to set a time limit, in minutes, the
hands free mode will stay on if a user forgets to turn it off after use. ETC recommends setting
this for 10-15 minutes. Device default is 10 minutes, max is 60 minutes.
•
Handset PTT Mode – This option should only be checked if a PTT handset will be connected to
the device. When selected the user will select the channel to Tx/Rx on, an indicator will
appear on the display above the selected channel and to talk the user will press the PTT
button on the handset
•
Footswitch PTT Mode – This option should only be checked if the device will have a footswitch
connected for activating PTT on a selected channel. Once active, channel buttons on device
CS-64 Administration and Set Up Guide
Page 14
party equipment
rd
Essential Trading Systems Corp.
Advertisement
Table of Contents
