Audio Settings Page - ETC CS-64 Administration & Setup Manual

2.7

Audio Settings Page

The Audio Settings page allows the administrator to adjust specific device properties not covered
in other configuration pages such as master volume settings, LCD contrast and other
miscellaneous settings. See Figure 7.
Figure 7
LCD Settings – Allows the administrator to adjust brightness & contrast of device display. Slide
•
right to increase, left to decrease.
Audio Settings – Allows the administrator to adjust master speaker volume & microphone gain
•
of device. Speaker & microphone level meters are provided as simple diagnostic tools to
confirm if device is working properly. Master volume level suggested is 70% and Mic Volume
level suggested is 65%.
Test Speaker – Pressing this button plays a test message on the device.
•
Start Announcement – If this box is checked the device will play a message indicating it is
•
being restarted any time the device experiences a reload or reboot.
Handsfree Timeout – This setting allows an administrator to set the time, in minutes, the
•
handsfree mode will stay on if a user forgets to turn it off after use. ETC recommends setting
this for 10-15 minutes. Device defaults to 10 minutes.
Handset PTT Mode – This option should only be checked if a PTT handset will be connected to
•
the device. When selected the user will select the channel to Tx/Rx on, an indicator will
appear on the display above the selected channel and to talk the user will press the PTT
button on the handset
Half Duplex – This options sets the device in half duplex mode i.e. speaker is muted when PTT
•
button is pressed. Option is checked by default.
CS-64 Administration and Set Up Guide Page 10 Essential Trading Systems Corp.