Vinotemp Element EL-32COMM-SS Owner's Manual page 13

Single-zone wine cooler
Table of Contents

Advertisement

Power
7
To turn off the appliance, touch the
Press
again to turn on the appliance. The
temperature set previously when you restart the appliance or reconnect after power cuts.
Setting the Temperature Control
You can select
touching the °C/°F Selector mark.
in blue color in the temperature display window. You can set the
by touching the UP and DOWN marks.
 The temperature will
 The temperature will
 Temperature range : - 18°C/ - 65°F
 The set temperature will appear in blue color in the LED display window.
Light switch positions are located inside the unit (shown above) for you to turn the backlight on/off.
Orange backlight
Blue backlight
If you turn on the Blue/Orange backlight at the same time, do not leave them both on for a long
time since it can cause a high level of energy consumption.
SHELVES
To prevent damaging the door gasket, make sure the door is fully opened when pulling shelves out of the
rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 90%.
Only pull out one shelf at a time. Never attempt to pull more than one.
DEFROSTING
The wine cooler defrosts automatically. The evaporator behind the rear wall of the unit automatically defrosts
and the condensate collects in the drainage channel behind the rear wall of the unit, and flows through the
drainage hole into the drip tray by the compressor, where it evaporates.
the
temperature display setting from Fahrenheit to Celsius degrees by
The
increase by
1°C or 1°F if you touch the
decrease
by
1°C or 1°F if you touch the DOWN mark once.
4
39
mark and hold for at least 5 seconds.
LED readout will show the original
Fahrenheit or Celsius degree indicator will appear
desired
temperature
UP mark once.
13

Advertisement

Table of Contents
loading

Table of Contents