Operating Your Wine Cooler - Vinotemp element EL-168COMML Owner's Manual

.

Operating Your Wine Cooler

V
I
The wine cooler should be placed in a position where the ambient temperature is
between 12-38℃/54-100℉. Humidity level is between 45~90%. If the position is above
N
or below this range, the performance of the unit may be affected. For example, placing
your unit in extreme cod or hot conditions may cause interior temperature to fluctuate.
O
NOTE:
T
 When you use the wine cooler for the first time or restart the wine cooler after
having been shut off for a long time, there could be a few degrees variance
E
between the temperature you select and the one indicated on the LED readout .
M
This is normal and it is due to the length of the activation time. Once the wine
cooler is running for a few hours everything will be back to normal.
P
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the wine
.
cooler will not start.
C
The controls of your wine cooler
O
M
Up
1
Used to raise (warm)the set temperature by 1℃ or 1℉.
Temperature Display
2
℃/℉ Display
3
Down
4
Used to lower (cool) the set temperature by 1℃ or 1℉.
Set temperature
5
press this bottom, press
temperature at any time, touch the UP or DOWN mark, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds.
℉/℃ Selector
6
Select the temperature display setting in Fahrenheit or Celsius degree.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
to set temperature. To view the "set"
i n f o @ v i n o t e m p . c o m
11