Table of Contents
Advertisement
Figure 4 Acceptable Mounting
Orientations
Installing the Internal LTO-3 (Model B) Half-Height Tape Drive
YES
Mount the internal drive in a 5.25-inch, half-height drive bay as follows:
1 As required:
a Save and close your open files and terminate all running applications.
b Shut down the workstation or server system.
c Disconnect the system AC power cord from the facility AC power receptacle.
2 Remove the cover from the workstation or server system.
Note: See your computer manufacturer's instructions for the proper procedures to
remove the cover.
3 Select an available 5.25-inch half-height bay and, if required, remove the bay cover.
4 Position the drive in the bay and align either the upper or lower mounting holes—
whichever is appropriate—with the holes in the chassis (see
5 Secure the drive using two M3.0 x 3 metric screws on each side
Caution: Using screws longer than 3 mm can damage the drive.
Do not
use screws longer than 3 mm to secure the internal LTO-3 (Model B)
Half-Height Tape Drive.
After mounting the internal LTO-3 (Model B) Half-Height Tape Drive, proceed to
Connecting the Internal Drive Interface and DC Power Cables
subsection.
YES
YES
Product Line
NO
figure
5).
in the following
7
Advertisement
Table of Contents
