Table of Contents
Advertisement
Figure 2 Internal Parallel SCSI
ID Configuration Jumper Pins
(Examples)
Installing the Internal LTO-3 (Model B) Half-Height Tape Drive
TP NC 8 4 2 1
TP NC 8 4 2 1
SCSI ID 2
SCSI ID 3
Note: Parallel SCSI controllers and host adapters generally use ID 7. In some systems,
the boot drive uses ID 0 or ID 1. Avoid configuring the LTO-3 (Model B) Half-
Height Tape Drive to these SCSI IDs.
Configuring the Internal Parallel SCSI Terminator Power
By default, terminator power is enabled on the internal parallel SCSI LTO-3 (Model B)
Half-Height Tape Drive. If you use this default setting, then the last device at the end of
the parallel SCSI bus must have either:
• A parallel SCSI bus terminator
• Terminator power enabled
See
figure 3
for examples of internal parallel SCSI bus termination.
To disable terminator power, remove the termination power (TP) jumper (see
TP NC 8 4 2 1
TP NC 8 4 2 1
SCSI ID 5
SCSI ID 9
Product Line
TP NC 8 4 2 1
SCSI ID 13
figure
2).
5
Advertisement
Table of Contents
