Table of Contents
Advertisement
Product Name Quick Start Guide
Restarting the Internal
Tape Drive System
Installing the Tabletop LTO-3 (Model B) Half-Height Tape Drive
Configuring the
Tabletop Parallel SCSI
Tape Drive
10
After connecting the internal drive interface and DC power cables:
1 Restart the workstation or server system.
2 Verify that the internal LTO-3 (Model B) Half-Height Tape Drive comes on and
completes the Power On Self Test (POST) functions.
3 As required, proceed to either:
•
Installing the LTO Driver Software
•
Registering the LTO-3 (Model B) Half-Height Tape Drive
To install the tabletop LTO-3 (Model B) Half-Height Tape Drive, complete the following
procedures in the order presented:
1 Depending on the interface configuration of the drive:
IF the drive interface is . . .
parallel Small Computer
System Interface (SCSI),
serial-attached SCSI (SAS),
2
Connecting the Tabletop Drive Interface and AC Power Cables
3
Restarting the Tabletop Tape Drive System
4
Installing the LTO Driver Software
5
Registering the LTO-3 (Model B) Half-Height Tape Drive
The factory-set default configuration of the tabletop parallel SCSI LTO-3 (Model B) Half-
Height Tape Drive is:
• SCSI ID: 6
• Terminator power: enabled
IF the default parallel SCSI ID
configuration is . . .
compatible with your system
SCSI bus,
on page 15
THEN . . .
proceed to
Configuring the Tabletop Parallel SCSI
Tape Drive
in the following subsection to configure
the SCSI ID.
there is no need to configure the SCSI ID, as SAS is
a point-to-point architecture. Skip to
the Tabletop Drive Interface and AC Power Cables
on page 11.
on page 14
on page 15, if required
THEN you can . . .
skip the following subsection and proceed to
Configuring the Internal Parallel SCSI Terminator
Power
on page 5.
Installing the Tabletop LTO-3 (Model B) Half-Height Tape Drive
on page 15
Connecting
on page 15
Advertisement
Table of Contents
