Table of Contents
Advertisement
Figure 8 Tabletop Parallel SCSI
ID Selector Switch
Connecting the
Tabletop Drive Interface
and AC Power Cables
Installing the Tabletop LTO-3 (Model B) Half-Height Tape Drive
IF the default parallel SCSI ID
configuration is . . .
already assigned to another
device,
Note: You cannot disable terminator power on a tabletop parallel SCSI drive.
Configuring the Tabletop Drive Parallel SCSI ID
Each device on the parallel SCSI bus must have its own unique SCSI ID. Use the push-
button SCSI ID selector switch on the drive back panel to change the SCSI ID of the
tabletop LTO-3 (Model B) Half-Height Tape Drive (see
Parallel SCSI ID selector switch
Note: Parallel SCSI controllers and host adapters generally use ID 7. In some systems,
the boot drive uses ID 0 or ID 1. Avoid configuring the LTO-3 (Model B) Half-
Height Tape Drive to these SCSI IDs.
After configuring the parallel SCSI ID, proceed to
Interface and AC Power Cables
As shown in
figure 9
and
figure
Height Tape Drives have connectors for:
• Either a 68-pin parallel SCSI cable (two connectors), or a 26-pin SFF-8088 mini-SAS
style interface cable
THEN you can . . .
change the configuration of either the other
device, or the LTO-4 Half-Height Tape Drive, as
described in the following subsection.
figure
Connecting the Tabletop Drive
in the following subsection.
10, the rear panels of the tabletop LTO-3 (Model B) Half-
Product Line
8).
11
Advertisement
Table of Contents
