Mounting The Internal Tape Drive - Quantum LTO-3 Quick Start Manual

Product Name Quick Start Guide
Figure 3 Internal Parallel SCSI
Bus Termination Examples
Mounting the Internal
Tape Drive
6
SCSI terminator
Tape drive
(no termination)
SCSI device
(termination
disabled)
SCSI controller
(termination
enabled)
Note: The internal parallel SCSI LTO-3 (Model B) Half-Height Tape Drive does not
provide SCSI termination. The last device at the end of the parallel SCSI bus
chain must have a SCSI bus terminator.
After configuring the parallel SCSI ID and bus termination power, proceed to
the Internal Tape Drive in the following subsection.
You can mount the internal LTO-3 (Model B) Half-Height Tape Drive either horizontally or
vertically, but not upside down (see
IF you mount the drive . . .
horizontally,
vertically,
SCSI terminator
figure 4).
THEN the . . .
base of the drive must be within 15 degrees of
horizontal.
side of the drive must be within 5 degrees of
horizontal.
Installing the Internal LTO-3 (Model B) Half-Height Tape Drive
SCSI device
(termination enabled)
Tape drive
(no termination)
SCSI controller
(termination enabled)
Mounting