i-PRO WV-S65340-Z4 Basic Information page 7

About dehumidifying device
• This product has dehumidifying device to
keep the inside at a low humidity level.
• Depending on conditions such as temper-
ature, humidity or the climate, condensa-
tion may form and it may take time to
dehumidify.
* The back cover of the sunshield and the
indication label are omitted.
What to do if "WARMING UP-PLEASE
WAIT" appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
The camera will be automatically restarted
when the inside the camera is warmed up by
the built-in heater. Please wait for a while.
We shall not be liable for content compen-
sation, losses of recorded or edited con-
tent and any direct or indirect consequent
damages caused by failure to record or
edit due to faults with this unit or the
microSD memory card. In addition, the
same provisions apply after unit is reparied.
About the CMOS image sensor
• When continuously shooting a bright light
source such as a spotlight, the color filter
of the CMOS image sensor may become
deteriorated and this may cause discolor-
ation. Even when changing the fixed
shooting direction after continuously
shooting a spotlight for a certain period,
the discoloration may remain.
• When shooting fast-moving subjects or
performing panning/tilting operations,
objects crossing the shooting area may
look to be bending askew.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury.
Do not use benzine, thinner, alcohol, or any
other types of solvents or detergents.
Otherwise, it may cause discoloration. When
using a chemical cloth for cleaning, read the
caution provided with the chemical cloth
product.
Dehumidifying
device
Cleaning of the dome cover
7
• Do not loozen or remove screws unless
instructed to do so in the product docu-
mentation.
• The camera position may be moved inad-
vertently while cleaning the camera body.
Restart the product or refresh the camera
position (position refresh) to correct the
camera position. Refer to the Operating
Instructions for further information.
• When cleaning the dome cover, use a
hose or spray to wash away grains of sand
and other deposits with fresh water that is
free from lubricants and silicon-based sub-
stances. If the dirt is still not removed, use
a soft sponge soaked in the fresh water
mentioned above and wipe off.
• Do not wipe the cover with a dry cloth (oil
components adhered to the surface may
spread or the rain wash coating may be
damaged).
• If the dirt cannot be wiped off with a damp
cloth, use a neutral detergent and thor-
oughly rinse off the detergent.
• Do not use organic solvent such as ben-
zine and thinner.
• Before using a spray, blow it in the air to
eliminate initial impurities.
* Improper cleaning of the dome cover may
cause the rain wash coating to become
less effective. In this case, in order to
restore the rain wash coating effect, a new
dome cover must be purchased to replace
the existing one. Consult with your dealer
or construction contractor.