Yaesu FTDX10 Reference Manual page 3

CAT
( Computer Aided Transceiver )
When performing software port configuration, select the COM port numbers that were confirmed using the
procedure above, use the two confirmed COM port numbers for each software function. The frequency and
communication mode and PTT control can be set from the software, and CW keying, digital communication,
etc. can be performed simultaneously.
When performing software port configuration, select the COM port numbers that were confirmed using the
procedure above.
・ If a "!" or "X" is displayed for the port on the Device Manager, uninstall and reinstall the virtual COM driver.
・ If a transceiver with a different serial number is connected and turned on, different COM port numbers
will be assigned to it, making it possible to perform individual COM port configurations for separate
transceivers.
・ When using the USB cable for TX control, the transceiver may switch to the transmit mode when the
computer is started.
・ Always close the application on the computer before disconnecting the USB cable.
2
Operation