Bernina Large Freearm Embroidery Hoop Quick Start Manual

1
I H G F
BERNINA International AG | CH-8266 Steckborn Switzerland | www.bernina.com | © Copyright by BERNINA International AG
1066855.00A.04
2022-03 EN
Large Freearm Embroidery Hoop
A B C
Information
Scope of delivery
• 1× Embroidery Hoop
• 1× Embroidery Template
• 2× Embroidery Template Holder
Purpose
• To embroider T-shirts, bags and long tubular fabric starting from a circum-
ference of 80 cm.
For your safety
E D
Before using this accessory, please read this instruction manual as well as the
instruction manual of your machine carefully.
Overview
A Embroidery Template Holder
B Embroidery Template
C Outer line for embroidery field (only for BERNINA 5-Series)
D Twist Lock
E Release Button
F Inner Ring
G Outer Ring
H Embroidery Hoop Connector
I Push button
Application
Preparing the Embroidery Hoop
> Attach the Template Holder to the Embroidery Template at the notches.
> Place the Embroidery Template in the inner ring.
> Before using the Embroidery Hoop for the first time, calibrate the
Embroidery Hoop in the Setup Program of the machine. Refer to the
instruction manual of the machine.
> Squeeze the Release Buttons underneath the Twist Lock.
– The locking mechanism is released.
> Remove the outer ring.
Hooping the fabric
> Mark the center of the embroidery motif on the fabric with a water-soluble
pen. For items with a closed seam, such as bags, make sure there is at least
7 cm of fabric from the inside left edge of the hoop to the closed seam.