Alarm Interfaces; Remote Interfaces; Mains Input; Installation - Calian SatService sat-nms ACU-19V User Manual

Antenna controller
Table of Contents

Advertisement

3.6 Alarm interfaces

The sat-nms ACU19V provides a dry contact Alarm interface. Please refer to chapter
Interfaces
to the antenna/ Pin descriptions
for more detailed informations.

3.7 Remote interfaces

The sat-nms ACU19V provides an ethernet (http) interface for remote controlling. An internal
webserver provides a clearly arranged webpage where all settings and states can be monitored
and controlled. Please refer to chapter
Operation
and
Remote control
for more detailed
information. A serial interface (RS232) is available on demand.

3.8 Mains input

The sat-nms ACU19V already contains all internal needed power supplies. As they are wide-
range types it is possible to connect nearly all worldwide available single phase mains. Please
refer to chapter
Specifications
for more detailed informations.

4 Installation

The following chapter describes how to install the ACU19V mechanically and electrically.
Additional a detailed start-up procedure is given in this chapter.

4.1 Mechanical installation

The sat-nms ACU19V is completely integrated into a 1RU 19inch case with standard mounting
holes. The case of the sat-nms ACU19V is not strong enough to carry the complete unit only on
the front mounting holes! Because of that, take care that the sat-nms ACU19V is placed onto a
bar guide that carries the complete weight of the sat-nms ACU19V. The screws have to be fixed
properly to keep the sat-nms ACU19V in its position.

4.2 Interfaces to the Antenna, Pin descriptions

ATTENTION! Electrical installation shall be carried out only by qualified personnel who are
instructed and aware of hazards of electrical shocks.
All connectors of the sat-nms ACU19V are located at the rear side of the case. The following
chapters show the standard pin configuration. If you have a non-standard version, please refer to
the documentation enhancement that shows the pin descriptions of it.

4.2.1 Connector Layout

Below the connector layout of the ACU19V is shown. The connector type is described together
with the corresponding pin description in the following chapter. The given connector type says
which connector you need on your cable !
(C) 2022, SatService GmbH
www.satnms.com
ACU-19V-UM-2209 Page 9/64

Advertisement

Table of Contents
loading

This manual is also suitable for:

Satservice sat-nms acu-19

Table of Contents