Mountz FGA V2 Operating Instructions

FGA ADJUSTABLE ADJUSTABLE TORQUE SCREWDRIVER
OPERATING INSTRUCTIONS OPERATING INSTRUCTIO
Rev 1.0 (6/15/2022)
How to Indentify a FGA v2 model
There are two ways to identify whether you have a v2 or a v1 model. There are two ways to identify whether you have a v2 or a v1 model.
1. The v2 models has separate battery access cover (see page 2) on the lower side of the The v2 models has separate battery access cover (see page 2) on the lower side of the
handle. The v1 models does not.
2. Second option is to move the locking bar Second option is to move the locking bar slide into the unlock position and adjust the
knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it
displays a firmware version, the model is a v2 model. displays a firmware version, the model is a v2 model.

Power on Display

Press the black lever button to view the digital display and current tool

Sleep Mode

When there is no activity of pressing the lever butting or adjusting the setting, When there is no activity of pressing the lever butting or adjusting the setting,
the display will timeout approximately within 20 seconds and then goes into the display will timeout approximately within 20 seconds and then goes into
Sleep mode. Press the black lever button to aw Sleep mode. Press the black lever button to awake the tool from Sleep mode.
Adjusting the Torque Setting
Units of Measurement
Press the black lever button while the display is powered on
torque measurement unit options available for
FGA Models
FGA-8, FGA-20 & FGA-40
FGA-80
Torque Setting
Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn Slide the locking bar slide mechanism to the unlock position. Use the black adjustment knob to change torque settings. Turn
the knob clockwise to increase torque and counterclockwise to decrease torque. After selecting your torque value, release the increase torque and counterclockwise to decrease torque. After selecting your torque value, release the increase torque and counterclockwise to decrease torque. After selecting your torque value, release the
locking bar slide, and it will return to its original position. locking bar slide, and it will return to its original position.
bottom-up.
SILICON VALLEY HEADQUARTERS
1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
igital display and current tool setting.
while the display is powered on to toggle through
for your FGA model.

Torque Measurement Units

Torque Measurement Units
ozf.in, lbf.in, cN.m, N.m, kgf.cm ozf.in, lbf.in, cN.m, N.m, kgf.cm
lbf.in, N.m, kgf.cm
SCREWDRIVER (V2)
Per ISO:6789-1, when certified, the tool is adjusted from the 1, when certified, the tool is adjusted from the
v2 model
v1 model
1