Mountz FGA V1 Operating Instructions

FGA V1 ADJUSTABLE ADJUSTABLE TORQUE SCREWDRIVER
OPERATING INSTRUCTIO OPERATING INSTRUCTIONS
Rev 1.0 (6/15/2022)
How to Indentify a FGA v1 model fro
There are two ways to identify whether you have a v2 or a v1 model. There are two ways to identify whether you have a v2 or a v1 model.
1. The v2 models has separate battery access cover (see page 2) on the lower side of the The v2 models has separate battery access cover (see page 2) on the lower side of the
handle. The v1 models does not.
2. Second option is to move the locking bar Second option is to move the locking bar slide into the unlock position and adjust the
knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it knob (CCW direction) below the torque range capacity. Once you pass the letter "L," if it
displays a firmware version, the model is a v2 model. displays a firmware version, the model is a v2 model.

Power on Display

Press the black lever button to view the digital display and current tool
Sleep Mode
The display stays on for 20 seconds then goes into Sleep mode. The display stays on for 20 seconds then goes into Sleep mode. Press the
black lever button to awake the tool from Sleep mode
Adjusting the Torque Setting
Units of Measurement
Press the black lever button while the display is powered o
torque measurement unit options available for
FGA Models
FGA-8, FGA-20 & FGA-40
FGA-125
SILICON VALLEY HEADQUARTERS
1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292 1080 North 11th Street, San Jose, CA 95112 | Phone: (408) 292-2214 | Fax: (408) 292-2733 | mountztorque.com
om FGA v2
igital display and current tool setting.
tool from Sleep mode.
while the display is powered on to toggle through
for your FGA model.
Torque Measurement Units Torque Measurement Units
ozf.in, lbf.in, cN.m, N.m, kgf.cm ozf.in, lbf.in, cN.m, N.m, kgf.cm
lbf.in, N.m, kgf.cm
SCREWDRIVER
v2 model
v1 model
1