Table of Contents
Advertisement
8.0 Adjusting and Aligning
the Front Wheel
Each Zip X3 is checked for straight tracking prior to leaving the
factory. In the unlikely event the Zip X3 is not tracking straight, the
front wheel can be adjusted to regain straight tracking as follows;
1.
Lock the swivelling front wheel [6.0] and run the Zip X3
forward to see if the Zip X3 veers left or right.
2.
Unlock the swivelling front wheel, swivel it to see the locking
latch in the middle of the two front wheels, as below Picture
on Left
3.
Unlock the latch by pulling down
4.
Adjust the direction by turning the thumb screws in the right
hand Picture. Alternate between cogs when adjusting -
suggest a quarter of a turn at a time
– To make the Zip X3 go Right - L/H screw anticlockwise,
R/H screw clockwise – [Up on both sides]
– To make the Zip X3 go Left - L/H screw clockwise,
R/H screw anticlockwise – [Down on both sides]
5.
Lock the latch by pushing it up.
Please note that there is a process in adjusting the tracking. It is
suggested that the users should do a little bit of adjustment, test
the tracking and then adjust again until the Zip X3 goes straight.
16
Advertisement
Table of Contents
