Filling The Refillable Containers; Flame Customization - Dimplex CDFI500-PRO Installation And User Manual

Operation

Filling the Refillable Containers

CAUTION: Allow at least five minutes for components to cool before disassembling the unit to refill.
When the water tank is empty, the flame effect will shut off and the LEDs will blink twice continuously. Follow these
steps to refill the tank:
1. Carefully remove the media and media plate.
2. Turn the On/Off switch to the 'off' position (0).
3. Remove the refill container by lifting upwards and outwards.
4. Refill the container with water.
!
NOTE: Normal tap water can be used in the Opti-myst
water. In the event your tap water is hard, you may use softened water or distilled water. If using distilled water,
it is recommended to add
notice that the unit is not producing mist as expected.
5. Screw the cap back on. Do not overtighten.
6. Return the refill container to the sump, with the tank cap facing down and the flat side of the tank facing outward.
7. Turn the On/Off switch to the 'on' position ( I ).
8. Carefully place media plate and media back into position.

Flame Customization

The CDFI500-PRO and CDFI1000-PRO come with inserts that allow you to customize the look of the flame.
To use the spacers, first break them along the break line (Figure 10). Second, insert into the nozzle at desired
locations. It is recommended to place them under any media that crosses through the flame, for example, logs.
To use the slots, insert them into the nozzle (Figure 11). A total of 3 slot inserts can be used in each nozzle.
Figure 10
/ tsp. of salt (0.5 mL) to the water reservoir; additional salt should only be when you
1
8
as long as the tap water is not considered to be hard
®
Figure 11
15