Carrier AR TXHQB Series Owner's Manual & Installation Manual page 35

Step 4: Connect signal and power cables
The outside unit's terminal block is protected
WARNING
ELECTRICAL OR WIRING WORK,
1.
USE THE RIGHT CABLE
H05VV-F or H05V2V2-F
determined by the maximum current of the
unit. The maximum current is indicated on
the nameplate located on the side panel of
the unit. Refer to this nameplate to choose
b. Strip the insulation from the ends of the
WARNING
ALL WIRING WORK MUST BE
2.
3.
terminal block and place it to the side.
4.
5.
into the terminal.
6.
7.
tape. Arrange them so that they do not
touch any electrical or metal parts.
8.
In North America
1.
2. Dismount caps on the conduit panel.
3. Temperarily mount the conduit tubes (not
4.
terminals on the terminal block.
5.
codes.
6.
7.
Terminal block
Please select the appropriate through-hole
User manual/
Installation manual
Connecting cable
G
Conduit panel
32