Mount Indoor Unit - Carrier AR TXHQB Series Owner's Manual & Installation Manual

Step 8: Mount indoor unit
If you installed new connective piping to
the outdoor unit,
1.
to Step 4.
2.
of the refrigerant pipes are sealed to
entering the pipes.
3.
refrigerant pipes, drain hose, and signal
4. Hook the top of the indoor unit on the
upper hook of the mounting plate.
5.
mounting by applying slight pressure to
the left and right-hand sides of the unit.
The unit should not jiggle or shift.
6.
bottom half of the unit. Keep pushing
along the bottom of the mounting plate.
7.
mounted by applying slight pressure to
the left and the right-hand sides of the
unit.
If refrigerant piping is already embedded
in the wall,
1. Hook the top of the indoor unit on the
upper hook of the mounting plate.
2.
the refrigerant piping, signal cable, and
drain hose.
Wedge
3. Connect drain hose and refrigerant
piping (refer efer to Refrigerant Piping
Connection section of this manual for
4. Keep pipe connection point exposed to
perform the leak test (refer to Electrical
Checks and Leak Checks section of this
5.
6.
propping up the unit.
7.
until the unit snaps onto the hooks along
the bottom of the mounting plate.
Keep in mind that the hooks on the mounting
plate are smaller than the holes on the back
ample room to connect embedded pipes to
the indoor unit, the unit can be adjusted left
depending on the model.
30-50mm
User manual/
Installation manual
30-50mm
28