Festool CTC MIDI I Instructions Manual page 20

English
quency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer­
ence will not occur in a particular installation. If
this equipment does cause harmful interfer­
ence to radio or television reception, which can
be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equip­
ment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the re­
ceiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
NOTE: Any changes or modifications not ex­
pressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
18.4 Canada: Notes (ISED)
This Class B digital apparatus complies with
Canadian ICES-003 and RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, in­
cluding interference that may cause undesired
operation of the device.
18.5 Canada: RSS Compliance Statement
This device complies with Industry Canada's li­
cence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, in­
cluding interference that may cause undesired
operation of the device. This device has been
designed and complies with the safety require­
ment for RF exposure in accordance with
RSS-102, issue 5 for portable conditions.
18.6 Canada: Radio frequency (RF) Exposure
Information
The radiated output power of the Wireless De­
vice is below the Innovation, Science and Eco­
nomic Development (ISED) radio frequency ex­
posure limits. The Wireless Device should be
used in such a manner such that the potential
for human contact during normal operation is
minimized.
20
The compliance distance between the user and
the Bluetooth module has to be 25/64"
®
(10 mm).