Page 5
CTL SYS 원본 사용 설명서 – 크레인 후크 또는 리프팅 장비를 이용해 공구를 들거나 운반하지 마십시오. – 공구가 기울어지지 않도록 주의하십시오. 안전 수칙 기울어진 장소에 공구를 놓지 마십시오. 기호 경고! 본 도구와 함께 제공된 모든 안전 경고, 기호 의미 지침, 그림, 사양을 확인하십시오. 아래의 지침을...
Page 6
/ 1.5 m/s 보호 등급 IP X0 먼지통 용량 4.5 l 치수 L x W x H 보관상자가 있는 CTL SYS 396 x 296 x 270 mm CTL SYS만 396 x 296 x 162 mm 중량 보관상자가 있는 CTL SYS 6.9 kg...
Page 7
X집진기를 끄고 약 5분 동안 식힌 다음 다시 켜십 규정을 준수하십시오. 시오. 한계치: 배기 공기가 청정 공기량의 최대 50% 집진기가 켜지지 않으면 Festool 고객 공식: 실내 공간 부피 V x 공기 재생률 L 서비스 센터에 문의하십시오. 작업 전에 아래의 사항을 확인하십시오.
Page 8
제조사 또는 서비스 센터에서만 정식 고객 서비스와 수리 서비스가 제공됩니다. 다음 XT-Loc를 이용해 집진기를 닫으십시오. 주소에서 가까운 지점을 찾아보십시오. 액세서리, 필터, 소모품의 주문 번호는 www.festool.com/Service Festool 카탈로그 또는 www.festool.com 에서 확인할 수 있습니다. Festool의 정식 부품만 사용하십시오. EKAT 주문 번호 확인: www.festool.com/Service 문제 해결...
Page 9
CTL SYS Original operating instructions – Observe all national safety regulations as well as the material manufacturer’s specifications! – Always use suitable protective equipment! Safety instructions – If intact following a visual inspection, work in a dry environment according to instructions! –...
Page 10
Protection category IP X0 Container capacity 4.5 l Dimensions L x W x H CTL SYS with storage box 396 x 296 x 270 mm only CTL SYS 396 x 296 x 162 mm Weight CTL SYS with storage box 6.9 kg...
Page 11
XSwitch off the dust extractor, allow to cool for Ensure there is adequate ventilation! Observe about 5 minutes, then switch on again. regional regulations! Not possible to switch on: Contact Festool Limit values: Exhaust air max. 50% of the clear customer service workshop. air volume...
The order numbers for accessories, filters Use only original Festool spare parts! EKAT and consumables can be found in the Order No. at: www.festool.com/Service Festool catalogue or on the internet at www.festool.com. XRegularly replace the filter bag and clean the container and seals. Troubleshooting...
Page 13
Transport Environment Do not dispose of the device in house- Observe the following instructions: hold waste! Recycle devices, accesso- – Before transportation, always close the T-Loc at ries and packaging! Observe the valid the dust extractor or connect to the storage box. national regulations.