Festool CTC MIDI I Instructions Manual page 16

English
12.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extraction stops automatically when
the maximum fill level is reached.
The bottom LED [1-15] lights up red.
► Switch off the mobile dust extractor [1-12].
► Open the locking clips [1-7] and remove the
top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and liquids
► Switch off and empty the machine immedi­
ately.
12.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
► Do not blow off any dust!
The exhaust-air outlet offers the option of di­
verting the exhaust air outside a building using
the suction hose.
► Open the grille in front of the exhaust-air
outlet [1-8].
► Insert the suction hose in the exhaust-air
outlet [1-8].
12.4 Cleaning the main filter and filter bag
manually
► In standby mode, press the MAN but­
ton [1-13].
► Set the suction power to the maximum set­
ting [1-14].
► Close the suction hose manually while at
the same time briefly pressing down the
cleaning lever [1-5] three times.
16
12.5 Changing the filter bag with minimal
dust
► Open the locking clips and remove the top
section of the machine [2].
► Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
► Fit the top section of the machine and close
the locking clips.
2
12.6 Changing the main filter [6]
► Remove the used main filter [1-6].
► Dispose of the used main filter in accord­
ance with statutory regulations.
► Insert the new main filter.
PO numbers for accessories, filters and
consumables in the Festool catalogue or
online at "www.festool.com".
NOTICE
Damage to the motor
► Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.