Operation Of Machine - STM MINI-ROCKETBOX PLUS+ User Manual

OPERATION OF MACHINE

MOUNT & REMOVE SUCTION CUP
Use the Mini-RocketBox™ PLUS+ on a solid,
flat surface such as a stainless steel table or
thick table-top surface.
Clean surface with alcohol and place
on the table. See the image below for
proper placement.
Press white button on suction cup
continuously until the button stays
depressed to the red line.
To remove suction cup, pry away rubber
edge of the cup.
USING THE MINI-ROCKETBOX™ PLUS+
Load trays into Mini-RocketBox™ PLUS+, tighten
wing nuts, and power ON.
Turn knob to Medium setting and begin adding
material, ensuring all material is spread evenly
to all cones.
Run the machine for approximately 40 seconds.
Turn the dial to HIGH for a full power final pack
for the last 10-15 seconds. May require longer
time for light, fluffy strains.
Helpful Tips
Sift material for better quality pre-rolls.
Add more material if cones don't fill completely.
Refer to density training videos for desired weight and
results. bit.ly/rb2-density-testing
9