Table of Contents
Advertisement
Before you connect the USB cable, you must install the driver. See the next chapter for driver installation
instructions. The only cable you should connect initially is the ADSL cable.
Place the Modem in a location so that you are able to view the LEDs. It should be placed in an area that is clean,
dry and ventilated. Make certain it is not placed near a heat source.
Connect the ADSL Cable
You can begin installing the Modem by performing the following steps:
1. Insert the Installation CD into the CD-ROM drive.
2. Insert one end of the ADSL cable (26 AWG twisted-pair telephone cable) into the telephone wall jack (RJ-
11 port).
3. Insert the other end of the ADSL cable into the ADSL port (RJ-11 port) on the Modem.
4. Follow the software installation instructions in Chapter 3.
DO NOT CONNECT THE USB CABLE YET!
You must install the software driver before you connect the device to your computer via the USB
cable. You will be instructed to connect the device at a later point during the installation process.
Connecting the USB cable at this point will initiate the Found New Hardware process and the
Found New Hardware wizard may select the wrong driver software for your ADSL connection.
Please wait until after you have installed the correct driver before connecting your new modem.
DSL-260I ADSL USB Modem User's Guide
3
M
ODEM
4
I
NSTALLATION
2
Advertisement
Table of Contents
