Supported Power Cords And Plugs - Cisco MDS 9148V-K9 Hardware Installation Manual

Cable and Port Specifications
Table 12: 10/100 BASE-T Management Port Cable Pinout
Pin
1
2
3
4
5
6
7
8
The following figure shows a schematic of the 10/100 BASE-T cable:
Figure 19: Twisted-Pair 10/100 BASE-T Cable Schematic

Supported Power Cords and Plugs

Each switch power supply unit requires one power cord. Cisco approved cords may be ordered with the
product. Standard power cords with a country specific plug can be used with wall outlets. Jumper power cords
can be used with cabinet outlets. The user may also source their own power cords for the product, as long as
they meet the power cord specifications for this product.
Note Only the standard power cords or jumper power cords ordered from Cisco are supported.
Signal
TD+
TD-
RD+
RD-
Not used
Not used
Not used
Not used
Cisco MDS 9148V-K9 Switch Hardware Installation Guide
Supported Power Cords and Plugs
53