Cisco MDS 9148V-K9 Hardware Installation Manual page 42

Removing a Fan Module
To remove an existing fan module, follow these steps:
Step 1
On the fan module that you are removing, press the two sides of the fan module handle next to where it connects to the
fan module and pull on the handles enough to unseat it from its connectors.
Step 2
Holding the handle, pull the module out of the chassis.
Caution Do not touch the electrical connectors on the back side of the module and prevent anything else from coming
into contact with and damaging the connectors.
Cisco MDS 9148V-K9 Switch Hardware Installation Guide
36
Installing the Cisco MDS 9148V-K9 Switch