Table of Contents
Advertisement
www.lazodecontrol.com
MULTI FLOW RATE Mode
MULTI FLOW RATE is very similar to the SINGLE FLOW RATE MODE,
except it adds an additional parameter for the number of locations.
This allows you to take several air flow measurements (i.e.
traverses) and get a total average, for example measuring flow rate
from multiple ducts to get an overall average.
The value of each point is the
average of TRIAL(1) to TRIAL(N).
The value of each location is the
average of POINT(1) to
POINT(M). The value of each
location will be stored in the
memory.
<Result>
Average(AVG): AVG (AVG(1)+ AVG(2)+
Maximum(MAX): MAX Maximum value from AVG(1) to AVG(L)
Minimum(MIN): MIN Minimum value from AVG(1) to AVG(L)
MENUaa1.NORMAL
aaaaaa2.DUCTaTYPE
aaaaaa3.CALCULATION
aaaaaa4.FLOWaRATE
aaaaaa5.DATAaOUTPUT
aaaaaa6.DATAaCLEAR
aaaaaa7.UTILITY
aaaaaa8.PRESSUREaZERO
SAMPLING MODE
1.SINGLEoFLOWoRATE
2.MULTIoFLOWoRATE
MULTI
(R20000/20000
1.SAMPLING(TIME)001ps
2.SAMPLING(n)110050
3.MEAS./LOC.oo010/010
4.DATA2STORAGE2?22YES
5.DUCT2ENTRY2NO.2221
6.SET2TO2START
+51 960 810 089
POINT(1)
avg(1)
POINT(2)
avg(2)
POINT(M)
avg(M)
LOCATION(1)
AVG(1)
LOCATION(2)
AVG(2)
LOCATION(L)
AVG(L)
Press
to enter the Main Menu.
Use
and press
.
Use
to select
2. MULTI FLOW RATE
.
As the same as the SINGLE mode, set
the following: 1. Sampling Time, 2. No.
Trial, 4. Data Storage, and 5. Duct
Entry No.
Use
to select
3. MEAS./LOC. and press
Use
to select the number of
MEAS. points (1 to 999) and press
Then use
to select the
number MEAS. locations (1 to 999) and
press
.
) N
) N
) N
) M
) M
) M
+AVG(L)) L
.
.
29
ventas@lazodecontrol.com
Advertisement
Table of Contents
