Table of Contents
Advertisement
IMPORTANT !
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
1.1 Health & Safety
Note: When servicing the Dishwasher, Health and Safety issues must be considered at all times. Specific
safety issues are listed below with their appropriate icon. These are illustrated throughout the service
information to remind service people of the Health and Safety issues.
1.1.1 Electrical Safety
Ensure the mains power has been disconnected before servicing the Dishwasher. If the
mains
when removing any electrical component or connection to avoid electrical shock.
1.1.2 Electrostatic Discharge
An anti-static strap is to be used as electrical static discharge (ESD) protection when servicing
electronic components.
1.1.3 Good Working Practices
Ensure the work area is in a tidy and orderly condition at all times so as not to cause a hazard
while service work is being completed. Always clean and tidy the Dishwasher and work area
after service is completed.
1.1.4 Isolate Water Supply
Turn off the water connection tap before servicing.
1.1.5 Water Leak Check
Check for water leaks as part of the testing after the service has been completed.
1.1.6 Insulation Test
Megger test to check insulation.
Warning: Short together the phase and neutral pins on the plug so as not to damage any
electronic circuitry.
1.1.7 Solvent and Excessive Heat Damage
Solvents and excessive heat can damage plastic surfaces.
1.1.8 Sheet Metal Edges
When working around cut sheet metal edges use appropriate gloves or protection to eliminate
the chance of receiving a laceration.
4
1 HEALTH & SAFETY
supply is required to be on to service the Dishwasher, make sure it is turned off
D D
D D D
D
Hide quick links:
Advertisement
Table of Contents
