Fisher & Paykel DW60FC1 Service Manual page 27

FC6 model Only
FAULT CODE
FC0 - Motor Alarm
(shown in display to
customer)
EE0
Shown in Service Mode Menu
E:
EC1
EC2
EC3
EC4
EC5
EC6
EC7
EC8
EC9
ECA
26
7 FAULT DIAGNOSTICS
POSSIBLE CAUSE
abort of wash cycle
deverter motor failed to start
motor driver device error
PWM signals inconsistency of BLAC
motor
motor winding test failed
BLAC motor too hot
lost control of motor
Resistance measurement of BLAC
motor failed
DC voltage too low for resistance
measurement
Invalid current during resistance
measurement
Motor current plausibility check failed
Motor current offset out of range
WHAT TO CHECK
1.Check the wiring harness connections
between motor and controller.
2.Replace the main board.
1.Check the wiring harness connections
between the motor and controller.
2.Replace the deverter motor
1.Check the wiring harness connections
between the motor and controller.
2.Replace the main board.
1.Check the wiring harness connections
between the motor and controller.
2.Replace the main board.
1.Check the wiring harness connections
between the motor and controller.
2.Replace the main board.
3.Replace the wash pump.
1. Visual check of the wash pump, is it
blocked?
2.Replace the wash pump.
1.Check the wiring harness connections
between the motor and controller.
2.Replace the main board.
3.Replace the wash pump.
1. Replace the main board.