Pairing With The Uh8-Rf V2 Wiring Centre - Heatmiser Wireless Series Instructions Manual

Pairing with the UH8-RF V2 Wiring Centre

Note: You can pair the Slimline-RF V3 to multiple channels on the UH8-RF V2.
Step 1, On the UH8-RF V2:
• Press and hold the pairing button on the desired channel until the output indicator LED
flashes. Pairing mode is now active on the UH8-RF V2.
Once the UH8-RF V2 detects the pairing signal from the Slimline-RF V3 the output light will turn off.
Step 2, On the Slimline-RF V3:
• Turn Off the thermostat by, holding down the Power button for 3 seconds...........
• Now hold down the H button for 3 seconds unit you see P1 in the top right hand
corner of the display....................................................................................................................
• Tap the H button once while P1 is shown to start a 99 second countdown...........
• During the countdown the thermostat will transmit a signal and flash the RF
icon at the top left hand corner of the display....................................................................
If pairing is successful, the countdown will jump straight to 00 followed by a blank
screen.
• Press the Power button on the thermostat once to turn the unit back On..............
If in mode 02, the hot water timer will automatically be paired to the HW channel.
If pairing is unsuccessful, eliminate a possible signal issue by repositioning the thermostat
closer to the receiver and repeat the pairing process again.
Model: Slimline-RF V3
12