Pairing With The Uh8-Rf - Heatmiser NeoAir V2-M Manual

Pairing with the UH8-RF Wiring Centre
Remove the cover from the UH8-RF.
The current channel number is set inside on the two dials, these
dials are at the top of the circuit board and look like this
(You need to set a unique channel number for each UH8-RF)
To control heating only, con gure the neoAir in mode 1.
To control heating & hot water, con gure the neoAir in mode 3. (See page 7)
On the neoAir:
• Use the Left arrow key to highlight
• Press and hold
• SETUP is now highlighted, press
• The display will show the number 01 in the top right hand corner.
• Press the Down arrow key twice, P2 is displayed in the top right corner.............................
• Press once .....................................................................................................................................................
UH8-RF
Channel Number
01- 99
for 3 seconds .............................................................................................................
once to access the setup menu................................
on the menu ...............................................................
Air - M
neo
Channel Number
5 5
0 0
(TENS) (UNITS)
Example showing
Channel No. 01
Zone Number
01- 08
Zone Type
rA = Radiators
UF = Under Floor
Heating
10