Fuel; Grounding - Westinghouse WGen12000c User Manual

FUEL

Fire and explosion hazard. Never use a gasoline
container, gasoline tank, propane connector hose,
propane tanks, or any other fuel item that is broken, cut,
torn or damaged.
Fire and explosion hazard. Never refuel the generator
while the engine is running. Always turn the engine off
and allow the generator to cool for two minutes before
refueling.
NOTICE
Do not use E15 or E85 fuel in this
product.
damage caused by stale fuel or
the use of unapproved fuels (such
as E15 or E85 ethanol blends) is
not covered by warranty. Only use
unleaded gasoline containing up to
FUEL REQUIREMENTS
• CLEAN, FRESH, unleaded gasoline, 87–93 octane.
•
available; non-ethanol fuel is recommended).
• DO NOT use E85 or E15.
• DO NOT use a gas oil mix.
• DO NOT modify the engine to run on alternate fuels.
• DO NOT fuel indoors.
•
USING FUEL STABILIZER
Adding a fuel stabilizer (not included) extends the usable
life of fuel and helps prevent deposits from forming that
can clog the fuel system. Follow the manufacturer's
instructions for use.
Always mix the correct amount of fuel stabilizer to gasoline
in an approved gasoline container before fueling the
stabilizer to treat the entire fuel system.
14 | Westinghouse Outdoor Power Equipment
Engine or equipment
FILLING THE FUEL TANK
Turn the generator OFF and allow to cool for a minimum
of two minutes before fueling.
Place the generator on level ground in a well ventilated
area.
Clean area around fuel cap and remove the cap slowly.
NOTICE
Make sure the gasoline container is internally clean and
in good condition to prevent fuel system contamination.
Install the fuel cap. Tighten securely.
NOTICE
Fuel can damage paint and plastic. Use caution when
avoid damage. Damage caused by spilled fuel is not
covered under warranty.
NOTICE
compressing it while removing it from the fuel tank.

GROUNDING

Shock hazard. Failure to properly ground the generator
can result in electric shock.
NOTICE
Only use grounded extension cords, tools, and
appliances, or double-insulated tools and appliances.
The generator neutral is bonded to the frame. There is a
permanent conductor between the generator (stator wire)
and the frame. If this generator will be used only with cord
and plug equipment connected to the receptacles mounted
on the generator, National Electric Code does not require
that the unit be grounded. However, other methods of
ASSEMBLY