Faq; Charging - VETEC V-LINK 67601 User Instructions

Selecti ng a frequency on the handheld display
*The channel setti ngs will remain when the dynamometer and display are turned off .
*The channel is as default set as the last two digits of your V-LINK serial number.

6.. FAQ

Anomalies
The device does not turn on
Display shows an incorrect
value
Display value is not reset to 0

7. Charging

V-LINK is charged using a standard high quality USB
charger. Always on stock at Vetec or available in any store.
Charge the dynamometer in your car, connected to your
computer or using a wall charger.
As the charger is not waterproof charging the unit in a safe
dry place is recommended. Place the dynamometer on a
stable surface and make sure it is turned off . Plug in and
charge up using the USB port on the rear of the
dynamometer.
Charge temperature 0°C to 45°C.
A fully discharged batt ery takes up to 6 hours to recharge.
The display shows the default channel.
The fi rst digit is blinking which means that it can be
changed using the arrows.
Select the channel that corresponds to the channel
of the V-LINK you want to operate.
Press ENTER to select channel.
Press RETURN to go back to weighing.
Possible causes
Discharged batt eries
Electronics defecti ve
More than 1 year since last
calibrati on
Malfuncti on of electronics
Has been overloaded
Has not been reset
Has been overloaded
- 9 -
Correcti ve acti ons
Charge the batt ery
Contact Vetec's service depart-
ment
Re-calibrate at Vetec service
department
Reset: Turn off and on and retest
Contact Vetec's service department
Press →0←
Contact Vetec's service depart-
ment.