Panasonic CS-MS9SD3H Service Manual page 27

Installation into the Ceiling

Attach the nuts and washers to the hanging bolts, then lift up and hook the main unit onto the hanging fixtures.

Check if the unit is leveled using a level or a vinyl hose filled partially with water.
Mounting Remote Controller Receiver
Install the remote controller receiver cable at least 5 cm away from electric wires of other appliances to avoid miss-operation (electromagnetic
noise).
■ Remove the bottom case.
Attention

Mounting the bottom case
1. Tighten the screws securely until the screw heads touch the bottom case. (Otherwise, loose screw heads
may hit the PCB and cause malfunction when mounting the top case.)
2. Do not over-tighten the screws. (The bottom case may be deformed, resulting in fall of the unit.)

Connecting the remote control wiring
1. Arrange the wires as shown in the illustration for
stored in the case. (Caught wires may destroy the PCB.)
2. Avoid wires touching parts on the PCB. (Caught wires may destroy the PCB.)
washer
Level
CAUTION
Screws 6
Hanging bolt (M10)
(locally purchased)
Hexagonal nut (M10)
9
(locally purchased)
Insert the driver
and slightly turn.
Bottom
Flat-blade
case
screwdriver
as in diagram below, avoiding unnecessary wires being
27