Sony VPL-CS1 Service Manual page 14

g p j g
Installing the Projector
This section describes how to install the projector.
The distance between the lens and the screen varies depending on the size of
the screen. Use the following table as a guide.
Distance between the screen and
the center of the lens
Unit: m (feet)
Screen size 40 60
(inches)
Minimum 1.6 2.4
Distance
(5.2) (7.8)
Maximum 2.0 3.1
Distance
(6.6) (10.0)
Note
You can not install the projector upside down, such as on a ceiling.
14
GB
Installing the Projector
80 100 120 150
3.2 4.0 4.9 6.1
(10.5) (13.2) (15.9) (20.0)
4.1 5.2 6.2 7.8
(13.5) (16.9) (20.3) (25.5)
Connecting the Projector
When making connections, be sure to do the following:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs properly; plugs that are not fully inserted often
generate noise. When pulling out a cable, be sure to pull it out from the plug,
not the cable itself.
Note
Supplied mouse cables may not work properly according to your computer.
Connecting with a Computer
This section describes how to connect the projector to a computer.
For more information, refer to the computer's instruction manual.
Notes
• The projector accepts VGA, SVGA, XGA, and SXGA signals. However, we
recommend that you set the output mode of your computer to SVGA mode for the
external monitor.
• If you set your computer, such as a notebook type, to output the signal to both your
computer's display and the external monitor, the picture of the external monitor may
not appear properly. Set your computer to output the signal to only the external
monitor.
For details, refer to the computer's operating instructions supplied with your
computer.
• Supplied mouse cables may not work properly according to your computer.
• This projector is compatible with a DDC2B (Digital Data Channel 2B). If your
computer is compatible with a DDC, turn the projector on according to the following
procedures.
1 Connect the projector to the computer by using the supplied HD D-sub 15 pin cable.
2 Turn the projector on.
3 Start the computer.
15
GB
Connecting the Projector