Aquacal TropiCal T170 Operation Manual page 58

3.8 Initial Cooling Recommendations
The following recommendations will reduce the amount of time required to cool a pool or cold plunge
application. If unsure of equipment cooling capability, review equipment data plate. See "Identifying
Model Specifications" on page 48.
1. Use the heat pump's "POOL/SPA" button to select the "POOL" group.
2. Select 48HR (48 hours) for the "SET TIME".
3. Confirm the mode has been set to "COOL" mode.
4. Set the desired temperature "COOL SETPOINT" for the water.
5. If a circulation pump has been connected to the heat pump, it will automatically activate.
6. Activate Turbo Boost Mode if equipped.
3.9 Service Mode
The heat pump can be set into a service mode where all connected devices including the heat pump can be
deactivated for servicing. While in service mode, connected devices / equipment can be manually activated as
needed.
Enter "Shortcuts" menus, then proceed
IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
PRESS "ENTER"
C
USE ARROWS TO
3
"ON"
When service is complete, repeat above
steps setting SERVICE MODE to "OFF".
Page - 54
PRESS MENU
A
BUTTON
USE ARROWS TO MENU
1
"SERVICE MODE"
ENTER TO SAVE
4
USE ARROWS TO
B
"SHORTCUTS"
PRESS ENTER TO EDIT
2
MENU TO EXIT, PRESS
& HOLD TO STATUS