Configuring Groups; Create A Group - Aquacal TropiCal T170 Operation Manual

1.8.f Configuring Groups
A group is used to control multiple devices (equipment) connected to the heat pump, either by manually
activating the group through a shortcut, or scheduling the group to activate at a specified time.
See "Using Shortcuts" on page 8.
l
See "Configuring Schedules" on page 18.
l
PLEASE NOTE:
The Pool and Spa groups can be activated by pressing the "Pool / Spa" button on the
control panel or scheduled to operate at a selected time.
See "Display Panel" on page 4.
l
f.1 Create a Group
EXAMPLES OF GROUPS THAT CAN BE CREATED:
A Custom Filtration Group -
o
This group could be used if the user didn't want to regulate the temperature of the water
o
the entire time the circulation pump is activated. A custom group can be created that
separates the amount of filtration time from the amount of time allowed for the heat pump
to heat or cool the water.
The example below shows a "FILTRATION" group being created manually.
A circulation pump will be added to the group.
Enter "Groups" menus, then proceed
IF UNIT IS ASLEEP,
SWIPE TO WAKE UP
EXAMPLES IN THIS SECTION:
f.1 Create a Group
f.2 Edit a Group
f.3 Delete a Group
PRESS "MENU"
A
BUTTON
PLEASE NOTE
This section only describes the
configuration of an already connected
circulation pump. To physically wire this
type of device to the heat pump, see the heat
pump's installation manual.
USE ARROWS TO
B
"GROUPS"
15
17
18
Page - 15