Table of Contents
Advertisement
3.7 SERIAL and IR CONTROL with FIFTEEN LOW POWER and TWO HIGH CURRENT RELAYS
This configuration expands the standard setup to provide serial and IR control with 15 low power output relays and two high
current output relays.
The A 6530 or A 6540 series wallplate is connected to the A 6505A Serial Hub via a CAT5e/6 cable. 24V DC power is con-
nected to the A 6505A by a plugpack with a 2.1mm jack or through the euro block terminals. The A 6505A in turn powers
the A 6530 or A 6540 series wallplate through the Cat5e/6 cable and powers the A 6510 and A 6515 by running a cable
from the 24DC In terminals of the A 6505A to the 24V In terminals of the A 6510 and A 6515.
The A 6505A Serial Hub can then be connected to up to two RS232 or RS485 controlled devices. IR control of multiple
devices is available through the IR repeater output and a total of seventeen relay outputs enable control of devices with
a closing contact. The relay contacts on the A 6505A are rated at 2A maximum and a set of normally open and normally
closed contacts are available for each relay. The relay contacts on the A 6510 are rated at 1A maximum with normally open
contacts only. The relay contacts on the A 6515 are rated at 16A maximum with a set of normally open and normally closed
contacts for each relay.
Redback® A 6541
Redback® A 6510
12
www.redbackaudio.com.au
Redback® A 6500A Programmable Control System
Redback® A 6500A Programmable Control System
Redback® Programmable Control System
(Cat5/6 Cable 50m Maximum)
CLOSING CONTACT
Relay OUT
11
10
9
8
7
6
5
4
3
2
1
RELAY CONTROLLED DEVICES
(CONTACTS MAX 1A)
Relay OUT
1
2
3
IR
RS232/
RS232/
A 1052 IR REPEATER
RS485
RS485
Relay OUT
2
1
RELAY CONTROLLED DEVICES
(CONTACTS MAX 16A)
Fig 3.7
Redback® Proudly Made In Australia 17
24V DC PLUGPACK
(MINIMUM 1A)
Redback® A 6505A
RELAY CONTROLLED
DEVICES
Redback® A 6515
Advertisement
Table of Contents
