Table of Contents
Advertisement
Redback® Programmable Control System
3.3 TWO RELAY SETUP (HIGH CURRENT, NO SERIAL or IR)
The high power setup provides up to two output relays for switching, with no serial or IR outputs. The relays are high current
outputs rated at 16A maximum and a set of normally open and normally closed contacts are available for each relay.
The A 6530 or A 6540 series wallplate is connected to the A 6515 via a CAT5e/6 cable. 24V DC power is connected to the
A 6505A by a plugpack with a 2.1mm jack or through the euro block terminals. The A 6515 in turn powers the A 6530 or
A 6540 series wallplate through the Cat5e/6 cable.
Redback® A 6541
3.4 THIRD PARTY RELAY CONTROL
The A 6510 and A 6515 relay distribution boxes can both be controlled by a third party device with either an RS232 or RS485
output, via serial commands which are described in the supplied programming manual.
NOTE: The A 6510 and A 6515 will receive serial only. They do not transmit any serial data.
See section 5.2 for serial wiring details.
Redback® A 6510
14
Redback® Proudly Made In Australia
(Cat5/6 Cable 50m Maximum)
Third Party Device
Relay OUT
12
11
10
9
8
7
6
5
4
3
2
1
RELAY CONTROLLED DEVICES
(CONTACTS MAX 1A)
Redback® A 6515
Relay OUT
2
1
RELAY CONTROLLED DEVICES
Fig 3.3
RS232/
RS232/
RS485
RS485
Relay OUT
2
1
RELAY CONTROLLED DEVICES
(CONTACTS MAX 16A)
Fig 3.4
24V DC PLUGPACK
(MINIMUM 1A)
(CONTACTS MAX 16A)
24V DC PLUGPACK
(MINIMUM 1A)
Redback® A 6515
www.redbackaudio.com.au
Advertisement
Table of Contents
