Table of Contents
Advertisement
Redback® Programmable Control System
3.6 SERIAL and IR CONTROL with THREE LOW POWER and TWO HIGH CURRENT RELAYS
This configuration expands the standard setup to provide serial and IR control with 3 low power output relays and two high
current output relays.
The A 6530 or A 6540 series wallplate is connected to the A 6505A Serial Hub via a CAT5e/6 cable. 24V DC power is con-
nected to the A6505 by a plugpack with a 2.1mm jack or through the euro block terminals. The A 6505A in turn powers the
A 6530 or A 6540 series wallplate through the Cat5e/6 cable and powers the A 6515 by running a cable from the 24DC In
terminals of the A 6505A to the A 6515 24V In terminals.
The A 6505A Serial Hub can then be connected to up to two RS232 or RS485 controlled devices. IR control of multiple
devices is available through the IR repeater output and a total of five relay outputs enable control of devices with a closing
contact. The relay contacts on the A 6505A are rated at 2A maximum and a set of normally open and normally closed con-
tacts are available for each relay. The relay contacts on the A 6515 are rated at 16A maximum with a set of normally open
and normally closed contacts for each relay.
Redback® A 6541
16
Redback® Proudly Made In Australia
(Cat5/6 Cable 50m Maximum)
CLOSING CONTACT
RS232/
RS485
Fig 3.6
Relay OUT
1
2
3
IR
RS232/
A 1052 IR REPEATER
RS485
Redback® A 6515
Relay OUT
2
1
24V DC PLUGPACK
(MINIMUM 1A)
Redback® A 6505A
RELAY CONTROLLED
DEVICES
RELAY CONTROLLED DEVICES
(CONTACTS MAX 16A)
www.redbackaudio.com.au
Advertisement
Table of Contents
