Preset Station Scan - Toyota TNS400 Owner's Manual

3. Touch the preset switch where you want to memorize the station until "P
appears on the sub display.
The selected station will be memorized.To manually set additional selected stations at the
remaining preset channels, repeat this procedure for each channel. Subsequently, when you
listen to the radio you will be able to select stations by touching the preset switches.
Memorizing stations automatically
1. Press the [FUNC/AF] button to establish the FUNCTION mode.
2. Press the [FUNC/AF] button until the sub display switches to ASM.
3. Press the [ENTER] button.
After "ASM ON" is displayed, automatic station selection will start. A search will be conducted
from the lowest frequency through progressively higher frequencies and stations with strong
reception will be memorized for preset registration numbers [] to [6]. When the operation has
ended the "ASM ON" indication will be cleared and the station memorized last (i.e. the one
memorized for P6) will continue to be received. Subsequently, when you listen to the radio you
will be able to select stations by calling up preset numbers.
Attention:
• Pressing the preset switches ([] to [6]) allows you to make one-touch station selections. The
frequency of the selected station is displayed on the preset switch.
• When a new station is set in memory, the station previously set in memory will be deleted.
• If there are fewer than six receivable stations, the stations set in the remaining switches will
remain unchanged.
Caution: If the vehicle's battery is disconnected (for repairs to the vehicle or for removal of the
main unit), all stations in memory will be lost. In this a case, set the stations in memory again.

5.6. Preset station scan

This function enables reception of all the stations in the preset switches to be played for five
seconds each.
1. Press the [FUNC/AF] button to establish the FUNCTION mode.
2. Press the [FUNC/AF] button until the sub display switches to P SCAN.
3. Press the [ENTER] button.
"P SCAN" will be displayed and the stations memorized for preset channels P to P6 will be
called up in order and received for five seconds each. To cancel the preset scan, press the
[FUNC/AF] button.
4 TNS400
MEMORY"